-
141
Transitions of deformation mechanisms in new metastable β-titanium Ti-1500G alloy
Published 2025-03-01Get full text
Article -
142
ANN Approach to Predict the Flow Stress of CMn (Nb-Ti-V) Micro Alloyed Steel
Published 2019-06-01“…This model has been shown to be more effective in predicting flow stress and results can also be used in the mathematical simulation of hot metal formation processes.…”
Get full text
Article -
143
ANN Approach to Predict the Flow Stress of CMn (Nb-Ti-V) Micro Alloyed Steel
Published 2019-07-01“…It is demonstrated that the LV neural network model has better performance in predicting the ?ow stress. …”
Get full text
Article -
144
Geological structure identification in geothermal manifestation of Lamongan Volcano Complex: A magnetic data analysis approach
Published 2024-01-01“…Some previous research has shown the existence of subsurface geological structures around Segaran hot springs in a northwest-southeast direction. …”
Get full text
Article -
145
Finding allowance distribution for root and connecting rod necks of crankshaft forging according to coordinate measurements
Published 2022-02-01“…The article analyzes various ways to ensure the geometric parameters of forgings in the processes of hot volumetric stamping. The fact of high efficiency of coordinate measurements of geometric parameters of forgings has been established to ensure the identification of negative production factors affecting the geometric accuracy of forgings manufacturing. …”
Get full text
Article -
146
The Measure of Residential Segregation of Socio-Economic Groups by Using Multigroup Indices in Shiraz City
Published 2016-09-01“…In general, the results show the occurrence of segregation in the medium amount to the high amount and by the calculated values of 0/7177, 0/5785, 0/5474 – 1, 0/5407, 0/3969, 0/3759, 0/3613, 0/3375 in the city of Shiraz. On the other hand, the use of Hot spots Analysis in the study area shows that the greatest concentrations of the socio-economic high group are in almost near the center of Shiraz city and the northwest of city, and for the socio-economic medium group exists in the west of city. …”
Get full text
Article -
147
Using a Combined FE-CA Approach to Investigate Abnormally Large Grains Formed by the Limited Recrystallization Mechanism in a Powder Metallurgy Nickel-Based Superalloy
Published 2025-01-01“…Powder nickel-based superalloy is the key material for hot-end components such as turbine disks and gas engine disks in aeroengines, and its microstructure uniformity has an important influence on the disks’ service performance. …”
Get full text
Article -
148
Lithium and strontium isotope hydrogeochemistry in Okayama and Tottori Prefectures, southwest Japan: implications for tracing slab-derived fluid
Published 2025-02-01“…Abstract Dehydration of the Philippine Sea Plate during subduction beneath the forearc region of southwest Japan releases fluids into the crust, potentially producing Arima-type fluids, which are characterized by anomalous hydrogen and oxygen isotopic compositions (δD and δ 18O). Arima-type fluids have been identified in limited hot springs near active faults, such as the Arima and Takarazuka hot springs. …”
Get full text
Article -
149
Properties of Particleboard made from Petung Bamboo (Dendrocalamus asper) and Wulung Bamboo (Gigantochloa atroviolacea) Particles with Extraction Treatment
Published 2020-07-01“…Bamboo has extractives, which the percentage of extractive was different based on bamboo species. …”
Get full text
Article -
150
Effect of Green Roofs on the Thermal Environment of Prototype Broiler Houses
Published 2025-01-01“…This study evaluated the effects of green roofs on the thermal environment and comfort indices in small-scale poultry house prototypes, comparing facilities with and without green roof installations. …”
Get full text
Article -
151
Enhancing the Quality of the Characteristic Transmittance Curve in the Infrared Region of Range 2.5–7 µm of the Optical Magnesium Fluoride (MgF2) Ceramic Using the Hot-Pressing Tec...
Published 2020-01-01“…The results present that, in comparison with using the hot-pressing technique in the open air, when using the hot-pressing technique in a vacuum environment, the transmittance increases about 4–10%, the characteristic transmittance curve is smoother and has fewer peak points, and the wide of peak points are smaller. …”
Get full text
Article -
152
Sanitary and hygienic issues in the design of individual heat supply systems
Published 2024-10-01“…It is important that fire safety, environmental standards, sanitary standards and standards of energy allocated per household are not violated. The parameters of HWS are quantitative. There are questions about the quality of sanitary water that has contact with human skin. …”
Get full text
Article -
153
An investigation into the impact of diapir structures on formation pressure systems: a case study of the Yinggehai Basin, China
Published 2025-01-01“…The results show that the diapir structure and its associated fault not only constitute the fluid transport system, but also make the deep overpressure transfer upward and accumulate into high pressure in the shallow formation, and the development of the associated fault destroy the integrity of the formation rock and reduce the strength of the rock. The upwelling of hot fluid changes the local geothermal conditions, reduces the hydrocarbon generation threshold of shallow source rocks, promotes the evolution of clay minerals, causes hydrothermal expansion, and enhances the shallow high pressure. …”
Get full text
Article -
154
Identification of climatic comfort areas Khuzestan province using multivariate analysis and spatial autocorrelation pattern with emphasis on architecture
Published 2023-06-01“…However, the areas of climatic comfort by spatial method have been limited somewhat. Results further indicated that the areas of climatic comfort have decreased significantly towards recent periods especially in cluster analysis and discriminant analysis that a trend of reduction has been remarkable in cluster analysis (from 23.60% in the first period to 17.60% in the fifth period) and discriminant analysis (from 26.97% in the first period to 14.98% in the fifth period).…”
Get full text
Article -
155
Study on interface structure and thermal conductivity regulation of Cu–In composite thermal interface materials
Published 2025-01-01“…In foil has excellent heat dissipation performance as a commercially available thermal interface material for high power devices. …”
Get full text
Article -
156
Pengembangan Tes Bentuk Soal Pilihan Ganda dan Uraian Berbasis Higher Order Thinking Skills (HOTS) pada Ranah Kognitif Mata Pelajaran Pemrograman Dasar (Studi pada SMK Negeri 12 Ma...
Published 2023-02-01“…From the international survey in 2018 (PISA), Indonesia has lowest score in the world, because the questions used still not measured Higher Order Thinking Skills (HOTS). …”
Get full text
Article -
157
Preparation and mechanical properties influencing of Ti2AlNb powder alloy
Published 2025-01-01“…The hot isostatic pressing process is a usual powder Ti2AlNb alloy preparation method to deeply study the influence of factors such as the powder-making process on the properties of Ti2AlNb powder alloy.Ti2AlNb pre-alloyed powders are prepared by plasma rotating electrode process and electrode induction melting gas atomization, respectively, and their mixed powders are characterized. …”
Get full text
Article -
158
On the development and analysis of a comprehensive police patrolling model
Published 2025-01-01“…The initial focus is on the development and analysis of a deterministic model which has proactive patrolling tasks consisting of hot spot and general patrolling duties. …”
Get full text
Article -
159
-
160
CONVERSION OF HEATING BOILER HOUSES IN MINI-THERMAL POWER STATIONS. Part 2
Published 2005-12-01“…The results of feasibility study are given in respect of heat generating plant (co-generating plant) capacity selection on the basis of Gas-Piston Unit for a specific heating boiler house of UE «Minskkommyteploset» in the paper.Keeping in mind the current situation at the power supply market in theRepublicofBelarusthe most profitable for heat supply enterprises are the variants with application of plants having heating capacity that corresponds to the base load of Hot Water Supply system or having electric power that covers boiler house auxiliaries.…”
Get full text
Article