Superior charge storage performance of optimized nickel cobalt carbonate hydroxide hydrate nanostructures for supercapacitor application by Mohit Bhatt, Bhavana Gupta, A. K. Sinha

“…These findings show that Ni2Co-CHH electrode material demonstrates great potential as electrode material for supercapacitor device fabrication.…”
Get full text

Precise Construction of Dual-Promising Anticancer Drugs Associated with Gold Nanomaterials on Glioma Cancer Cells by P. Baby Shakila, Abdurahman Hajinur Hirad, Abdullah A. Alarfaj, Samer Hasan Hussein-Al-Ali, Beza Mulugeta

“…This work aimed to determine the CTX and PT encapsulated with AuNMs against human glioma U87 cancer cells. The fabrication of the AuNMs achieved a negative surface charge, polydispersity index, and the mean sizes. …”
Get full text

Karakteristik Mekanik Komposit Polyester E-Glass dengan Stacking Sequences [0°, 90°, 0°] by Ilhamdi Ilhamdi, Dony Hidayat, Fadli Febriyan

“…Meanwhile other materials seemed to have fixed set after fabrication. Nowadays, one of the widely developed structural composite is polymer based composite with inorganic reinforcement. …”
Get full text

Impact of Occlusal Schemes on Implant-Supported Overdentures by Rene Kuriakose, Achuthan Nair, Malak S. Bamigdad, Deepika R. Pai, Nadeem A. Rahman, Lino Paul

“…The overdentures were fabricated and adjusted according to the assigned occlusal scheme. …”
Get full text

A flexible PI/MXene triboelectric nanogenerator for energy harvesting and motion monitoring in table tennis by Dazhong Xu, Xiaoxin Ma, Yong Ma

“…A polyimide/MXene (MXene) spinning film and cellulose acetate/polyamide 6 were used to fabricate a triboelectric nanogenerator (PC-TENG) for efficient mechanical energy harvesting. …”
Get full text

Highly sensitive non-enzymatic glucose sensing using Ni nanowires and graphene thin film on the gate area of extended gate electric double-layer field-effect transistor by Sheng-Chun Hung

“…This configuration significantly amplifies the electrical signal, thereby enhancing the sensor's sensitivity. The fabricated EGEDL-FET glucose sensor demonstrates a wide linear range from 0.05 mM to 5 mM, high sensitivity of 1043 mA μM−1 cm−2, and a low detection limit of 51 nM. …”
Get full text

Adsorption Characteristics of Chitosan-Modified Bamboo Biochar in Cd(II) Contaminated Water by Anxiang Huang, Wenlian Bai, Shoulu Yang, Zhongwei Wang, Nengying Wu, Yanxiong Zhang, Ning Ji, Dan Li

“…The purpose of this study was to fabricate a low-cost and eco-friendly adsorbent using bamboo biochar (BB), a kind of charcoal composed of high Brunauer–Emmett–Teller surface area and variety of functional groups, and chitosan as substrates for remediation of Cd(II) in Cd(II) contaminated water and characterized the functional group characteristics, surface morphology, and Cd(II) adsorption effect using the Fourier transform infrared (FT-IR), scanning electron microscope (SEM), and energy-dispersive X-ray spectrometer (EDS). …”
Get full text

Strategic Review: The CZTS Thin-Film Using Tandem and Multi-Junction Solar Cell by Saif Adnan Muhamad, Methaq Hadi Lafta

“…In this study, a strategic review of fabrication technology and the CZTS (Cu2ZnSnS4) thin film solar cell using tandem and Multijunction structures is discussed. …”
Get full text

Autotransplantation of a Third Molar to Replace Compromised Molar With the Individual Three-Dimensional Printed Ultrasonic Osteotome: A Case Report by Cheng Bi, Wen Zhang, Bin Peng

“…A custom-designed, tooth root–shaped ultrasonic osteotome was fabricated using 3D printing technology to match the shape of Tooth #32. …”
Get full text

Numerical Analysis of Hybrid Steel Beams with Trapezoidal Corrugated Web Nonwelded Inclined Folds by Yasir M. Alharthi, Ibrahim A. Sharaky, Ahmed S. Elamary

“…Three-dimensional FE models were developed considering the nonlinear properties of materials and geometric imperfection and validated using five hybrid specimens that were fabricated and tested experimentally by the authors. …”
Get full text

Cinéma et lien : une enquête intime auprès d'une famille italienne en Lorraine by Marion Froger, Émilie Tullio

“…For the past ten years, two French researchers – Fabrice Montebello et Jean-Marc Leveratto - have been taking an interest in the relations between workers of Italian origins living in Lorraine and cinema, as well as the social practices which derive from them. …”
Get full text

Microbially Induced Calcium Carbonate Plugging for Enhanced Oil Recovery by Chenpeng Song, Derek Elsworth

“…The following explores the microscopic characteristics of MICP-plugging and its effectiveness in permeability reduction. We fabricate artificial rock cores composed of Ottawa sand with three separate grain-size fractions which represent large (40/60 mesh sand), intermediate (60/80 mesh sand), and small (80/120 mesh sand) pore sizes. …”
Get full text

Triple-Resonance Wideband Sector Patch Antenna Under 1.25-Wavelength by Jian Yu, Shan-Shan Gu

“…As an experimental validation, the sector patch antenna with a flared angle of 180° and a low profile of 0.069-wavelength is fabricated and measured. The results demonstrate an impedance bandwidth of 45.9%, a 3 dB axial ratio (AR) bandwidth of 12.1%, and an enhanced tilted angle and range, with the maximum CP beam tilted angle reaching 42° and a tilted range of 34°. …”
Get full text

Robotically-Assisted Coronary Artery Bypass Grafting by Thierry A. Folliguet, Alain Dibie, François Philippe, Fabrice Larrazet, Michel S. Slama, François Laborde

Get full text

Performance Analysis and Optimisation During Machining of Al-ZrB2 Reinforcement-Based Metal Matrix Nanocomposites Using Coated and Uncoated Insert by Seema V. Yerigeri, Vaijanath V. Yerigeri

“…In this present research, focus is on the experimental study of the performance enhancement during machining operations on the fabricated different aluminium-based metal matrix nanocomposites (Al-MMNC) by employing temperature sensors and a dynamometer to monitor the material behaviours. …”
Get full text

Caregivers’ Knowledge, Attitude, and Practice towards Pressure Injuries in Spinal Cord Injury at Rehabilitation Center in Bangladesh by Niraj Singh Tharu, Monzurul Alam, Shristi Bajracharya, Gautam Prasad Chaudhary, Jitendra Pandey, Mohammad A. Kabir

“…The KAP factors that require higher priority were positioning and turning the patient, preventing skin breakdown, assessing weight changes over time, interest in patient care, additional care for PIs, frequently changing the individual’s position, priority to PI care, interest in other types of care other than PIs, using special cushions, consulting doctors on a regular basis, being aware of clothing and fabrics, proper transfer technique, pressure relief, and skin inspection, among others.…”
Get full text

High-Power MHz to 100s of GHz Circuits and Systems for Nuclear Fusion Reactors With Examples From SST-1 and ITER by Kamal K. Samanta

“…The paper also highlights material selection, design, fabrication, and implementation challenges and techniques for high-power amplifiers and systems. …”
Get full text

Study on the Seismic Performance of Box-Plate Steel Structure Modular Unit by Hui Mao, Guang-chong Qin, Tao Lan

“…To study the seismic performance of the box-plate steel structure system, two three-storey single box-plate steel structure space stress-bearing unit test pieces have been designed and fabricated according to the 1 : 3 reduced scale. In addition, the quasi-static loading test has been performed on the test pieces where the destruction process, destroy mode, bearing capacity, hysteretic behavior, etc., have been studied and the impact of reinforcing measures with a corner or not on the seismic performance of test pieces has been mainly analyzed. …”
Get full text

Removal of Organic Dye Using Graphene-based Composite: Isotherm and Kinetic Studies by Preeti ., Meena Bhandari, Neeraj Kumari

“…In the present study, Graphene oxide (GO) and Graphene oxide-montmorillonite (GO-based Montmorillonite composites) composite was fabricated successfully and used further for the extraction of cationic pollutant, Malachite green (MG) oxalate. …”
Get full text

The Performance of Different AgTiO2 Loading into Poly(3-Nitrothiophene) for Efficient Adsorption of Hazardous Brilliant Green and Crystal Violet Dyes by Sara A. Alqarni

“…Various methods were performed to confirm the fabrication of the binary P3NT/AgTiO2 NCs adsorbents, such as FTIR, XRD, SEM, and EDX. …”
Get full text