-
1581
Microstructure Formation and Dry Reciprocating Sliding Wear Response of High-Entropy Hypereutectic White Cast Irons
Published 2024-12-01“…The research investigates the solidification process of the alloys using Computer-Aided Cooling Curve Analysis (CA-CCA) and characterizes the microstructures through X-ray diffraction (XRD) and scanning electron microscopy (SEM). The wear behavior of the developed alloys is evaluated through reciprocating sliding wear tests, revealing the impact of varying chemical compositions on wear resistance. …”
Get full text
Article -
1582
Synthesis of Polyaniline/Graphene Oxide/Azobenzene Composite and Its Adjustable Photoelectric Properties
Published 2020-01-01“…Both composites were carefully investigated by scanning electron microscopy (SEM), Fourier transform infrared spectroscopy (FT-IR), and thermogravimetric analysis (TGA). …”
Get full text
Article -
1583
Transformation induced plasticity (TRIP) due to precipitation during continuous tempering of quenched and tempered steels
Published 2025-01-01“…In this work, tempering TRIP of three different Q&T steels has been studied by means of dilatometry, hardness measurements, and scanning electron microscopy. The heating rate, as well as the direction and level of applied stress, have been varied. …”
Get full text
Article -
1584
Effect of Nickel Content on the Corrosion Resistance of Iron-Nickel Alloys in Concentrated Hydrochloric Acid Pickling Solutions
Published 2017-01-01“…Various electrochemical and spectroscopic techniques such as potentiodynamic cyclic polarization (CPP), open-circuit potential (OCP), electrochemical impedance spectroscopy (EIS), potentiostatic current-time (PCT), and scanning electron microscopy (SEM), and energy dispersive spectroscopy (EDS) have been employed. …”
Get full text
Article -
1585
The Effect of Zeolite Na-X and Clinoptilolite as Functional Fillers on the Mechanical, Thermal and Barrier Properties of Thermoplastic Polyurethane
Published 2025-01-01“…Finally, the obtained films were characterized by Fourier Transform Spectroscopy (FT-IR, ATR), thermal analysis (TGA and DSC), frequency sweep test, scanning electron microscopy (SEM), mechanical tensile test and oxygen permeability test. …”
Get full text
Article -
1586
Facile Method for Obtaining Gold-Coated Polyester Surfaces with Antimicrobial Properties
Published 2020-01-01“…The changes induced in the treated polymer samples were investigated in terms of AuNp adsorption efficiency on polyester film by contact angle, profilometry, Scanning Electron Microscopy (SEM), Attenuated Total Reflectance Spectroscopy-Fourier Transform Infrared (ATR-FTIR), and X-ray Photoelectron Spectroscopy (XPS) measurements. …”
Get full text
Article -
1587
Effect of Electrolyzed Cassava Starch-Gelatin Coating on Biochemical Properties and Ripening of Banana ( Musa acuminata L.) Fruits
Published 2022-09-01“…The micrographs of scanning electron microscopy showed very thin coating layers (<25.2 um) with continuous network topology and no cracks. …”
Get full text
Article -
1588
The Effect of CuO on the Thermal Behavior of the High-Energy Combustion Agent of the Al/MnO2 System
Published 2019-01-01“…In addition, field emission scanning electron microscopy (FE-SEM) that could characterize the mixture morphology and thermogravimetric-differential scanning calorimetry (TG-DSC) that could indentify the exothermic and endothermic reactions and measure mass change were carried out. …”
Get full text
Article -
1589
The injectable hydrogel loading cannabidiol to regulate macrophage polarization in vitro for the treatment of chronic enteritis
Published 2024-10-01“…Method: The study designed and constructed GelMA + CBD, and its surface morphology was observed by scanning electron microscopy, and its pore size, swelling rate and release rate were evaluated to evaluate its bioactivity and biosafety. …”
Get full text
Article -
1590
Performance and Characterization for Blend Membrane of PES with Manganese(III) Acetylacetonate as Metalorganic Nanoparticles
Published 2015-01-01“…The membrane morphology, mechanical properties, and performance were presented. The scanning electron microscopy (SEM) images have displayed a typical asymmetric membrane structure with a dense top layer due to the migration of Mn(acac)3 nanoparticles to membrane surface during the phase inversion process. …”
Get full text
Article -
1591
Characteristics of Nanocrystallite-CdS Produced by Low-Cost Electrochemical Technique for Thin Film Photovoltaic Application: The Influence of Deposition Voltage
Published 2017-01-01“…All the annealed films show energy bandgap of 2.42 eV. Scanning electron microscopy and energy dispersive X-ray analyses show that grains on the surface of the films tend to get cemented together after annealing with prior CdCl2 treatment while all the films are S-rich.…”
Get full text
Article -
1592
The Effect of Different Vegetable Oils on Cedar Wood Surface Energy: Theoretical and Experimental Fungal Adhesion
Published 2022-01-01“…The Environmental Scanning Electron Microscopy (ESEM) has shown that P. commune (PDLd10) and A. niger were found unable to adhere to the wood surface after treatment with sunflower and rapeseed oils. …”
Get full text
Article -
1593
Macro-meso failure mechanism and strength criterion of frozen weakly cemented sandstone under triaxial unloading
Published 2025-01-01“…The microfracture characteristics of the damaged surface were studied by scanning electron microscopy (SEM).ResultsThe results show that compared with conventional triaxial compression and room temperature triaxial compression tests, the strength and plastic deformation characteristics of FWCS during unloading were significantly weakened, with transverse deformation and volume strain increased, showing obvious dilatancy characteristics. …”
Get full text
Article -
1594
The assembly factor Reh1 is released from the ribosome during its initial round of translation
Published 2025-02-01“…Reh1-bound ribosomes are also strongly enriched for initiator tRNA, indicating they are associated with early elongation. Using cryo-electron microscopy to image Reh1-bound 80S ribosomes, we found they contain A site peptidyl tRNA, P site tRNA and eIF5A, indicating that Reh1 does not dissociate from 60S until translation elongation. …”
Get full text
Article -
1595
Investigation of dissolution resistance of blank and gas-nitrided carbon steels in stationary SAC305 solder alloy melt
Published 2018-01-01“…Evidences of dissolution reactions and other degradation processes were searched for using scanning electron microscopy and energy dispersive X-ray spectroscopy. …”
Get full text
Article -
1596
High-Titre Neutralizing Antibodies to H1N1 Influenza Virus after Mouse Immunization with Yeast Expressed H1 Antigen: A Promising Influenza Vaccine Candidate
Published 2019-01-01“…In this study, we demonstrate that the recombinant H1 vaccine based on the hydrophilic haemagglutinin (HA) domain and produced in the yeast system elicited high titres of serum haemagglutination-inhibiting antibodies in mice. Transmission electron microscopy showed that H1 antigen oligomerizes into functional higher molecular forms similar to rosette-like structures. …”
Get full text
Article -
1597
Unleashing the Potential of Biochar Composite as Organic Nutrient Source: Implications as Soil Ameliorant, Seed Yield, and Physiological Attributes of Helianthus annuus L.
Published 2024-01-01“…Biochars associated with nutrient acquisition were characterized through Fourier transform infrared (FTIR) spectroscopy, scanning electron microscopy (SEM), and energy dispersive x-ray (EDX) spectroscopy. …”
Get full text
Article -
1598
A peripheral subepithelial network for chemotactile processing in the predatory sea slug Pleurobranchaea californica.
Published 2024-01-01“…We pursued anatomy and connectivity of previously described ciliated putative sensory cells on OV papillae. Scanning electron microscopy (SEM) confirmed paddle-shaped cilia in clusters. …”
Get full text
Article -
1599
The effect of the amount of Y2O3 doped to the MA6000 alloy produced by mechanical alloying method on wear behavior
Published 2022-01-01“…Sintered MA6000- X% Y2O3 superalloys were characterized by scanning electron microscopy (SEM), energy-dispersive spectroscopy (EDS), X-ray diffraction (XRD) analysis, density, and hardness measurements. …”
Get full text
Article -
1600
Effect of morphology on electron drift mobility in porous TiO2
Published 2004-01-01“…The relationship between the drift mobility and film morphology is discussed with the aid of scanning electron microscopy studies.…”
Get full text
Article