The Influence of the Ratio of Circumference to Cross-Sectional Area of Tensile Bars on the Fatigue Life of Additive Manufactured AISI 316L Steel
The static and dynamic loading capacities of components depend on the stress level to which the material is exposed. The fatigue behavior of materials manufactured using additive technology is accompanied by a pronounced scatter between the number of cycles at the same stress level, which is signifi...
Saved in:
| Main Authors: | , , , , |
|---|---|
| Format: | Article |
| Language: | English |
| Published: |
MDPI AG
2024-11-01
|
| Series: | Metals |
| Subjects: | |
| Online Access: | https://www.mdpi.com/2075-4701/14/11/1246 |
| Tags: |
Add Tag
No Tags, Be the first to tag this record!
|
| Summary: | The static and dynamic loading capacities of components depend on the stress level to which the material is exposed. The fatigue behavior of materials manufactured using additive technology is accompanied by a pronounced scatter between the number of cycles at the same stress level, which is significantly greater than the scatter from a material with the same chemical composition, e.g., AISI 316L, but produced by rolling or forging. An important reason lies in the fact that fatigue cracks are initiated almost always below the material surface of the loaded specimen. Thus, in the article, assuming that a crack will always initiate below the surface, we analyzed the fatigue behavior of specimens with the same bearing cross section but with a different number of bearing rods. With a larger number of rods, the circumference around the supporting part of the rods was 1.73 times larger. Thus, experimental fatigue of specimens with different sizes showed that the dynamic loading capacity of components with a smaller number of bars is significantly greater and can be monitored by individual stress levels. Although there are no significant differences in loading capacity under static and low-cycle loading of materials manufactured with additive technologies, in high-cycle fatigue it has been shown that the ratio between the circumference and the loading cross section of tensile-loaded rods plays an important role in the lifetime. This finding is important for setting a strategy for manufacturing components with additive technologies. It shows that a better dynamic loading capacity can be obtained with a larger loading cross section. |
|---|---|
| ISSN: | 2075-4701 |